Abstract
To compare the time-zero load to failure of a quadrupled, single-tendon, all-inside anterior cruciate ligament (ACL) reconstruction graft construct with (supplemented) and without the incorporation of inner-limb whipstitch sutures (control) into a tibial suspensory fixation button.
Eight matched pairs of peroneus longus tendons were prepared according to a quadrupled, all-inside ACL soft-tissue graft technique with 1 side serving as a control and the contralateral side supplemented. The constructs were biomechanically tested for strain in the inner and outer limbs during a preconditioning protocol, single-cycle load to failure, and elongation of the whole construct.
Ultimate load to failure was significantly higher in the supplemented group: 797.5 ± 49.6 N (95% confidence interval [CI], 763.13-831.87 N) versus 719.6 ± 69.6 N (95% CI, 671.38-767.82 N; P = .044). Less graft elongation at failure was observed in the supplemented group (3.1 ± 1.5 mm; 95% CI, 2.07-4.17 mm) versus the control group (21.0 ± 21.2 mm; 95% CI, 6.31-35.69 mm; P = .052). The number of grafts undergoing a 5-mm or greater change in length at failure was 1 of 8 in the supplemented group versus 5 of 8 in the control group (P = .038).
Inner-limb supplemental tibial fixation results in higher time-zero load to failure and decreased graft elongation in a quadrupled, single-tendon, all-inside ACL reconstruction graft construct.
The weak point of a single-tendon, quadrupled, all-inside ACL graft construct is the tendon-to-tendon suturing to secure the inner limbs of the graft. Adding supplemental fixation by incorporating the sutures from the inner limb to the tibial suspensory fixation button leads to a higher time-zero load to failure and decreased graft elongation.
